Table of Contents
Advertisement
Solution 6000-IP
Installation Manual
Comms > Remote Access >
RAS Security PIN
The RAS security PIN programmed here must match
the security PIN programmed in the customer file of the
Solution Link RAS upload/download database otherwise
a connection to the panel cannot be established.
1) Press [MENU] + [5] + [3] + [1]. The keypad will
display the current RAS Security PIN. The default =
12345678.
RAS Security PIN
12345678
Press OK to SAVE
2) Using the numeric keys, enter all the digits of the
new RAS security PIN. You can change a single digit
by scrolling the cursor left or right.
3) Press [OK] to save and exit or press [MENU] to exit
without saving.
Comms > Remote Access >
Log Threshold
The control panel can store up to 2000 system events in its
built in history log. A newly installed panel will have 100%
of its log space available for new events (0% full). As the
panel starts to store events in the log, the capacity for new
events is reduced. The history log is 100% full when event
999 is stored in memory. Event 2000 will start to overwrite
the oldest events in the log.
When the Log Threshold option is programmed, the panel
will send a 'Log Threshold' report to the base station when
the event log reaches the percentage as set since the last
Solution Link session.
If the event log reaches 100% capacity before a Solution
Link RAS session is established then the system will send a
'Log Overflow' report. The panel will also log these events
in its memory.
1) Press [MENU] + [5] + [3] + [2]. The keypad will
display the current threshold limit. The default is
70% full.
Log Threshold
070 Percents
Press 0-9 OK to SAVE
2) Using the numeric keys enter the new threshold
limit, then press [OK] to save and exit or press
[MENU] to exit without saving. There is no need to
enter the % symbol.
9-2
Comms Programming
MENU 5-3-1
1
2
3
4
5
6
7
MENU 5-3-2
7
0
Each time a Solution Link RAS session is established
i
with the panel, the log information will be uploaded
Note
to the Solution Link database where it can be
reported on or archived for later use
8
Comms > Remote Access >
User RAS PIN
The user RAS PIN must be changed from factory default
for Site Manager upload/download sessions.
Use keys 0 - 9 to program User RAS PIN + [OK] to save.
1) Press [MENU] + [5] + [3] + [8]. The keypad will
display the current User RAS PIN.
User RAS PIN
00000000
Press 0-9 OK to SAVE
2) Use the numeric keys to program the user RAS PIN
required, then press [OK] to save and exit, or press
[MENU] to exit without saving.
%
MENU 5-3-8
0
0
0
0
0
0
0
Bosch Security Systems 10/22 BLCC615I
0
Advertisement
Chapters
Table of Contents
