Control Panel And Wash Mode - Champion M4.2 Series Installation/Operation Manual With Service Replacement Parts

Operation
UH330 ADA Control Panel
The illustration below shows the operator controls and temperature displays for the UH330 ADA.
ON
OFF/DRAIN
POWER
Wash Temperature
ON-OFF/DRAIN
Digital Display
Power Switch
Wash Mode
Turn the power off to the dishwasher if it will be left unattended
1. Close the door.
2. Push the dishwasher ON-OFF/DRAIN switch UP to turn the power ON.
3. The power switch will illuminate and the machine will fill with water. The cycle light
flashes during the fill cycle.
4. Wait approximately 30 minutes until the wash temperature gauge indicates a minimum of
150ºF/66ºC.
5. Scrap the wares to remove large food particles.
6. Load the dish rack into the machine. Wash one dish rack at a time.
NORMAL
EXTRA
HEAVY
CYCLE
7. The NORMAL cycle setting is the default cycle and does not have a green indicator light.
The normal cycle is approximately 2-1/2 minutes long.
8. The EXTRA cycle is selected by pushing the cycle button once. The EXTRA green indicator
TEMPERATURE
WASH
Final Rinse Temperature
Digital Display
! VERY IMPORTANT !
for an extended period of time.
START
DETERGENT
RINSE RINSE AID
PRIME
Prime
Push button
Cycle Selector
Push button
Push the Cycle button once for Extra Cycle.
Push twice for Heavy Cycle.
Push the Cycle button three times to cancel
the selection and return to Normal Cycle.
Continued next page.
Operation
NORMAL
EXTRA
HEAVY
CYCLE START
Start
Time Select
Push button
Lights
Cycle Light
19