Pump Adjustments - Detergent And Rinse-Aid Dispensing Pumps - Champion M4.2 Series Installation/Operation Manual With Service Replacement Parts

Detergent and Rinse-aid Dispensing Pump Adjustments
Chemical Dispensing Pump Adjustments
The amount of dispensed chemical is determined by the run time of the dispensing time.
Refer to the photo below:
1. The chemical dispensing pump run adjustment screws are located on the end of the
chemical circuit board swing-out bracket.
2. It is not necessary to swing the bracket out to make adjustments, but if desired, remove
the mounting nut (A) and swing the bracket (B) out and to the right.
3. Refer to the next page for adjustment instructions.
B
Contact a chemical supplier for detergent and rinse-aid chemicals. The chemical supplier must
adjust the chemical dispensing pumps for water hardness and food soil types.
! ATTENTION !
A
B
! VERY IMPORTANT !
Installation
15