Start-Up; Parameterization - Siemens SIMOVERT FC Series Operating Instructions Manual

Master Drives
CBD
01/23/98
5

Start-up

5.1

Parameterization

...Section, Start-up / parameterization "Expert application" of the drive Instruction Manual
yes
Option boards?
P052 = 4
no
CBD in
slot +1.B2?
no
CBD in
slot +1.B3?
no
P695 = 0 .. 65535
P053 = x
P052 = 5
Further information in the Section, start-up / parameterization "Expert application" of the drive Instruction
Manual.
Fig. 5.1 Parameterization "hardware configuration" of CU2. CUVC and DC Master are similar with different parameter numbers.
36
5 Start-up
5.1 Parameterization
Possible option boards:
SCB, TSY, CB, TB
"Hardware configuration" function selection
yes
P090 = 1
yes
P091 = 1
P696 = 170 ... 172
P697 = 120 ... 122
P705 = 0 .. 2 Baud rate
P918 = n
CBD bus address (0 < n < 63)
Exit "hardware configuration"
P052 = 0
Setting the telegram failure time in ms (0 = deactivated)
Parameterizing enable CBD (refer below)
Function selection"drive setting"
CBD in slot +1.B2
CBD in slot +1.B3
I/O Assembly for polled I/O produced
connection path.
I/O Assembly for polled I/O consumed
connection path.
SIMOVERT MASTER DRIVES
Siemens AG 477 759 4070 76 J AA-74
Betriebsanleitung / Operating Instructions