05.1999
3
Installation, Connecting-up
3.1
RIF
NOTES
Siemens AG
6SE7087-6CX84-3DD0
SIMOVERT MASTERDRIVES
The board is installed by snapping it onto a previously mounted DIN
mounting rail. The cabling to the components must be established on
the plant side.
The board does not provide protection against direct contact.
Protection against direct contact (shock protection) must be ensured by
incorporating it in a housing or in a higher-level system (e.g. cabinet).
Shielded cables must be used, and the board must be grounded at X80
or X81 in order to prevent EMC noise.
Perfect functioning of the board cannot be guaranteed if the permissible
cable length is exceeded.
Power and control cables must be separately routed.
Resolver-Interface
Installation, Connecting-up
3-1