Start-Up; Start-Up Steps - Siemens Compact PLUS 6SE7024-1EP85-0AA0 Operating Instructions Manual

All manuals and user guides at all-guides.com
05.2005
3

Start-up

3.1

Start-up steps

After removing the packaging, please check that the unit
Unpack and
is intact and undamaged. Only intact units may be
check the unit
started-up. Please also check that the unit is complete.
Mount the unit in conformance with the requirements at
Mount the unit
the point of installation and the EMC instructions.
Connect the
Starting with the protective conductor, please connect
protective conductor,
the supply cable, the external braking resistor and the
the supply cable, the
external 24 V incoming supply. When laying the cables,
external braking resistor
please observe the EMC instructions. During this work
and the external 24 V
step, please do not yet connect the DC link buses.
incoming supply
Power up the external
111
24 V incoming supply
Power up the
After powering up the line voltage, the LED "Run" will
line voltage,
light up on the rectifier unit.
carry out function test
De-energize the line
voltage and the external 111
24 V incoming supply
Connect the DC link buses and form the connection to
Connect the DC link
the converters.
Siemens AG 6SE7087-2NP85-0AA0
SIMOVERT MASTERDRIVES Operating Instructions
Start-up
See section
"Transport,
Storage,
Unpacking"
See section
"Installation" and
"Installation in
Conformance
with EMC
Regulations"
See section
"Connecting-up"
and "Installation
in Conformance
with EMC
Regulations"
111
111
111
See section
"Connecting-up"
3-1