Table of Contents
Advertisement
3. Once the unit is powered on, select and hold the Marriage button on the projector for 5 to 25
seconds.
The projector turns on the light source and displays a test pattern with the projector's IP
address and any currently active alarms.
Resetting the projector IP address to the default
Use the following method to reset the projector IP address to the default value when no touch panel is
installed.
1. Connect the projector to the theater network using an Ethernet cable.
2. Make sure the projector is not in Standby mode by selecting the recessed button between the
USB-C port and the USB port on the Video Input panel.
Selecting the recessed button transitions the projector from Standby to powered on.
CineLife+ User Guide
020-103073-10 Rev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Operating the projector
17
Advertisement
Table of Contents
