Huawei FusionPower6000 UPS5000-H-600 kVA-FT User Manual page 63

UPS5000-H-600 kVA-FT(M)
User Manual (FusionPower6000)
Item
Battery type
Battery voltage (lead-
acid battery)
Nominal discharge
current (lead-acid
battery)
Maximum discharge
current (lead-acid
battery)
Battery cold start
Charger output power
Battery string sharing
Charging voltage
(lead-acid battery)
Issue 02 (2024-01-05)
Specifications
● Lead-acid battery (VRLA)
● SmartLi: For the supported version, contact technical support.
180–600 V DC
● 12 V batteries (15–50 batteries, 0 by default)
– 20–50 batteries: not derated
– 17–19 batteries: derated to 80%
– 15 or 16 batteries: derated to 70%
● 2 V batteries (90–300 batteries, 0 by default)
– 120–300 batteries: not derated
– 102–119 batteries: derated to 80%
– 90–101 batteries: derated to 70%
NOTE
● The number of batteries is 0 by default and needs to be set based on site
requirements. Batteries have no neutral wire, and an odd number of batteries
are supported.
● When the UPS works in normal mode, if the actual load rate exceeds the
threshold that could trigger battery derating, an output overload alarm is
generated.
1359 A (240 V, twenty 12 V batteries in standard configuration)
1627 A. It is the end-of-charge (EOD) current of twenty 12 V batteries in
standard configuration, that is, one hundred and twenty 2 V battery cells
(1.67 V/cell).
If a utility power outage occurs, batteries can start the UPS to supply
power to loads.
The maximum charge power is 15% of power of a single module, and
the charge current is limited to 30 A.
● Lead-acid battery: Battery string sharing is supported in a parallel
system. No battery is shared by default.
● SmartLi 2.0: Battery string sharing is supported in a parallel system.
No battery is shared by default.
● SmartLi 3.0: Battery string sharing is not supported.
● Equalized charging voltage: 2.35 V/cell
● Float charging voltage: 2.25 V/cell
Copyright © Huawei Digital Power Technologies Co., Ltd.
3 Technical Specifications
56