Table of Contents
Advertisement
Super H13SRA-(T)F User's Manual
2280 M.2 Device Installation
1. Locate the pre-installed standoff on the 22110
mounting hole. Remove the standoff screw
and set it aside.
2. Using a hex socket screwdriver, remove and
then reinstall the standoff to the position of the
2280 mounting hole.
3. Insert the M.2 device or the heatsink assembly into the M.2 socket at a 30-degree angle
and press it down.
Standard M.2 device
4. Tighten the standoff screw to secure the M.2 device or the heatsink assembly into place.
Do not overtighten so as to avoid damaging the M.2 device.
Standard M.2 device
M.2 device with Supermicro heatsink
M.2 device with Supermicro heatsink
36
Advertisement
Table of Contents
