Table of Contents
Advertisement
Super H13SRA-(T)F User's Manual
Pre-boot Wake On LAN
Use this feature to set Pre-boot Wake on LAN (WOL). The options are Disabled and
Enabled.
VLAN Mode
Use this feature to disable/enable the virtual LAN mode, which enables the use of a VLAN
tag. The options are Disabled and Enabled.
VLAN ID (Available when "Legacy VLAN Mode" is set to Enabled)
Use this feature to set the virtual LAN ID. Enter a valid value between 1–4094. The default
setting is 1.
Boot Retry Count
Use this feature to set the number of retries when a boot failure occurs. The options are No
Retry, 1 Retry, 2 Retries, 3 Retries, 4 Retries, 5 Retries, 6 Retries, and Indefinite Retries.
Blink LEDs
Use this feature to identify the physical network port by blinking the associated LED. The
default setting is 0 (up to 15 seconds).
The following information is displayed:
•
Link Status
•
Physical Link Speed
•
Chip Type
•
PCI Device ID
•
Bus:Device:Function
•
Permanent MAC Address
•
Virtual MAC Address
•
Restore Defaults
110
Advertisement
Table of Contents
