Table of Contents
Advertisement
Chapter 4: UEFI BIOS
Support RDMA
Use this feature to disable/enable the RDMA support for this port. The options are Disables
and Enabled.
DCB Protocol
Use this feature to disable/enable the DCB Protocol. The options are Disabled, Enabled
(IEEE only), CEE (only), Both (IEEE preferred with fallback to CEE).
LLDP nearest bridge
Use this feature to disable/enable the LLDP nearest bridge state. The options are Disabled
and Enabled.
Default EVB Mode
Use this feature to set the default Edge Virtual Bridging (EVB) mode. The options are VEB,
VEPA, and None.
Enable PME Capability
Use this feature to disable/enable the PME Capability support. The options are Disabled
and Enabled.
Flow Offload
Use this feature to disable/enable the Flow Offload mode. This figure is supported on Linux
DPDK only. The options are Disabled and Enabled.
Adapter Error Recovery
Use this feature to disable/enable the recovery of firmware from fatal errors without manual
intervention, host reboot, and power cycle. The options are Disabled and Enabled.
MBA Configuration Menu
Option ROM
Use this feature to disable/enable the legacy boot protocols for the Option ROM. The options
are Disabled and Enabled.
Legacy Boot Protocol
Use this feature to set the non-UEFI boot protocol. The options are PXE and NONE.
Boot Strap Type
Use this feature to set the boot strap method used to boot to the operation system. The
options are Auto Detect, BBS, Int 18h, and Int 19h.
109
Advertisement
Table of Contents
