Table of Contents
Advertisement
Super H13SRA-(T)F User's Manual
DIMM Installation
Note: The DDR5 DIMM module is NOT hot-swappable and be sure to disconnect
power for a minimum of 20 seconds before inserting or removing it.
1. Insert the desired number of DIMMs into the
memory slots based on the recommended DIMM
population table in this user's manual. Locate
DIMM memory slots on the motherboard as shown
on the right.
2. Align the DIMM module key with the receptive
point on the single-latch DIMM slot.
3. Push the release tab outwards to unlock the slot.
4. Align the notch on the end of the module against
the receptive point on the end of the slot.
5. Press both ends of the module straight down into
the slot until the module snaps into place.
6. Push the release tab to the lock position to secure
the module into the slot.
DIMM Removal
Press the release tab on one end of the DIMM module
to unlock it. Once the DIMM module is loosened,
remove it from the memory slot.
Note: Removing a DDR5 DIMM module at a
slant angle will cause module damages. It is
strongly recommended that you lift the module
straight up out of the slot.
Warning! Please do not use excessive force when pressing the release tabs on the ends of the
DIMM socket to avoid causing any damage to the DIMM module or the DIMM socket. Please
handle DIMM modules with care. Carefully follow all the instructions given on Page 1 of this
chapter to avoid ESD-related damages done to your memory modules or components.
Receptive Point
34
LAN
BMC
CTRL
H13SRA-TF
REV:1.01
DESIGNED IN USA
Key
Notch
Release Tab
Press both notches
straight down into
the memory slot.
Advertisement
Table of Contents
