Table of Contents
Advertisement
VIONiC encoder system quick-start guide
This section is a quick-start guide to installing a VIONiC encoder system.
More detailed information on installing the system is contained on
page 10
and
page 11
of this installation guide.
*
†
The optional Advanced Diagnostic Tool ADTi-100
and ADT View software
can be used to aid installation and calibration.
(A-6165-0100)
INSTALLATION
Ensure scale, readhead optical window and mounting faces are clean and free from obstructions.
Connect the readhead to receiving electronics and power‑up. The set‑up LED on the readhead will flash.
Install and align the readhead to maximise signal strength over the full axis of rotation as indicated by a Green flashing LED.
CALIBRATION
Cycle the power to the readhead to initiate the calibration routine. The LED will single flash Blue.
Rotate the axis at slow speed (< 100 mm/s), ensuring the readhead does not pass a reference mark, until the LED starts double flashing Blue.
No reference mark
Reference mark
Move the readhead back and forth over the reference mark until
If a reference mark is not being used, the calibration routine should now
the LED stops flashing.
be exited by cycling the power. The LED will stop flashing.
The system is now calibrated and ready for use. Calibration values, Automatic Gain Control (AGC) and Automatic Offset Control (AOC) status are stored in readhead non-volatile memory at power down.
NOTE: If calibration fails, restore factory defaults by obscuring the readhead optical window on power-up
(page
12). Repeat the installation and calibration routine.
*
For more details refer to the Advanced Diagnostic Tool ADTi-100 and ADT View software quick-start guide (Renishaw part no. M-6195-9321) and
Advanced Diagnostic Tool ADTi-100 and ADT View software user guide (Renishaw part no. M-6195-9413).
†
The software can be downloaded for free from
www.renishaw.com/adt
VIONiC REXM20/REXT20 installation guide
9
Advertisement
Table of Contents
