Table of Contents
Advertisement
Advanced Settings
Advanced Settings
Function
Monitoring mode within
AUTO Operation and ECONO
MODE (ON/OFF)
Setting at the time of purchase: ON
The sensitivity of the sensors decrease while
the fan is stopped during Monitoring mode.
If you do not want the sensitivity of the
sensors to be decreased, set to "OFF".
• When set to "OFF", Monitoring mode will not be
performed.
Airflow rate range for AUTO
FAN (4 levels/3 levels)
Setting at the time of purchase: 4 levels
If you are concerned about the operation noise
during AUTO FAN MODE/MOIST MODE/AUTO
Operation, switch from "4 levels" to "3 levels".
„ Airflow rate range
4 levels: "Quiet" "Low" "Standard" "High"
3 levels: "Quiet" "Low" "Standard"
31
Setting can be performed either
during operation or while operation is
stopped.
Press
for about
5 seconds, and when a
short beep sounds, press
while continuing
to hold down
.
When a short beep
sounds, release
.
Setting can be performed either
during operation or while operation is
stopped.
Press
for about
5 seconds, and when a
short beep sounds, press
while continuing
to hold down
When a short beep
sounds, release
and
.
1
The humidity setting lamps
(Low) blinks, then lights up.
[Blinking → Lit up]
According to the current setting,
the ECONO MODE lamp will be
displayed as follows.
[Blinking → Lit up]
and
"ON"
The AUTO FAN MODE lamp
blinks, then lights up.
[Blinking → Lit up]
According to the current setting, the
FAN lamp will be displayed as
follows.
.
[Unlit]
"4 levels"
[Unlit]
"OFF"
[Blinking → Lit up]
"3 levels"
Advertisement
Table of Contents
