Settings Of Modes Within Econo Mode - Daikin MCK70YVM Operation Manual

Advanced Settings
Advanced Settings
Operating panel

Settings of Modes within ECONO MODE

If you wish to set ECONO MODE and AUTO operation monitoring mode to "OFF"
You can set ECONO MODE and AUTO operation monitoring mode to "OFF". (Setting at time of purchase: ON)
If you are concerned about the sensitivity of the dust/PM2.5 sensor, odour sensor, or humidity sensor, set to "OFF".
1.
Hold down
.
(Setting can be performed either during operation or while operation is stopped.)
2.
When a short beep sounds, release
• The HUM lamp "
The ECONO MODE lamp will light up or blink depending on the setting status.
3.
Press to change the setting.
• Each press turns the ECONO MODE lamp ON or OFF.
(The HUM lamp "
To turn Monitoring mode ON
Turn on the ECONO MODE lamp.
To turn Monitoring mode OFF
Turn off the ECONO MODE lamp.
• Setting is indicated using the ECONO MODE lamp. If the ECONO MODE lamp does not change, unplug the unit, wait at
least 5 seconds, then re-insert the power supply plug and repeat the above procedure from the beginning.
4.
Press
• A short beep sounds and the HUM lamp "
lamp also blinks.
5.
While the lamp is blinking, unplug the power supply plug, wait at least 5 seconds, and then insert the
power supply plug again. Setting is now complete.
• If this procedure is not performed, the unit will not return to regular operation mode.
Note
Settings are remembered even if the unit is unplugged.
25
HUM lamp (Low)
for about 5 seconds and when a short beep sounds, press
(Low)" and ECONO MODE lamp blinks for about 5 seconds and then lights up.
(Low)" will remain lit up.)
after selecting the new setting.
and .
Setting at time of
ON
purchase
OFF
(Low)" will blink. When monitoring mode is turned ON, the ECONO MODE
MODE ECONO lamp
while pressing