Table of Contents
Advertisement
2
Press
to change the setting*.
Each press cycles between "ON" and
"OFF".
"ON"
"OFF"
Press
to change the setting*.
Each press cycles between "Low",
"Normal" and "High".
"Low"
"Normal"
* If the lamps do not change even after the settings were changed, unplug the unit, wait at least 5 seconds, then re-insert the power supply plug and
repeat the above procedure from the beginning.
Press
A short beep sounds, the AUTO
operation lamp blinks, and the set
Humidity setting lamp will blink.
"ON"
Press
A short beep sounds, and the set FAN
lamp will blink.
"Low"
"High"
3
.
[Blinking]
"OFF"
.
"Normal"
"High"
Advanced Settings
4
While the lamp is blinking,
unplug the power supply
plug, wait at least
5 seconds, and then insert
the power supply plug
again.
Setting is now complete.
Power supply plug
Power socket
• If this procedure is not performed,
the unit will not return to regular
operation mode.
• The settings will be remembered
even if the power supply plug is
removed.
30
Advertisement
Table of Contents
