Table of Contents
Advertisement
Read First
Names of Parts and Operations
Operating / Indicator panel
Operations and operating status
will be notified by tones.
• Operation start ................. 2 quick beeps
• Setting change ................. 1 short beep
• Operation end .................. 1 long beep
• When not usable .............. 3 short beeps
• Notification ....................... 3 long beeps
Water supply lamp (Red)
• When water in the water tank is depleted during
Humidifying Operation, a tone (3 long beeps) will sound
and the lamp will light up.
• Stop operation, unplug the power supply plug, and then fill
the water tank with water.
• To stop the notification tone (3 long beeps) from sounding,
change the setting.
• If 3 long beeps sound and the lamp lights up even though
water is in the water tank.
Streamer lamp (Blue)
Lights up according to the operation status of the streamer.
Humidity sensor lamp
Indicates the level of humidity in 3 colours: blue, orange, red.
Lamp colour
Red
Indoor humidity
0-20
(%)
„ After operation is started, the lamp will light blue for
about the first 30 seconds regardless of humidity level.
PM2.5 sensor lamp
Indicates the volume of dust in 3 colours: blue, orange, red.
• Blue indicates that the air is clean.
Lamp colour
PM2.5 concentration
(μg/m
)
3
„ After operation is started, the lamp will light blue for
about the first 1 minute regardless of volume of dust.
9
►Page 16, 17
►Page 33, 34
►Page 50
►Page 28
Orange
Blue
Orange
Red
21-29
30-60
61-70
71-100
Blue
Orange
Red
0-12
13-24
≥ 25
Daikin eye
Displays the condition of the air selected with
blue, orange, red.
• If "μg/m
3
" is selected
Lights up in the same colour as the PM2.5 sensor lamp.
• If "°C" is selected
Lights up in the colours displayed below, according to the current
indoor temperature.
Red
Orange
Lamp colour
Indoor temperature
≤ 10
(°C)
• If "%" is selected
Lights up in the same colour as the humidity sensor lamp.
„ If the responsiveness of the PM2.5 sensor is poor, change
the sensitivity setting of the sensor.
„ The responsiveness of the PM2.5 sensor may be poor
when airflow rate is high such as "Turbo". This is not a
malfunction because the airflow rate is strong and the dust
is sucked into the air inlet before it reaches the
PM2.5 sensor.
PM2.5 sensor detection range
Detectable matter
house dust, tobacco smoke, pollen, mite droppings and
remains, pet hairs, diesel particulate matter
Sometimes detectable
steam, oil smoke
in 3 colours:
Blue
Orange
Red
11-17
18-28
29-35
►Page 29, 30
≥ 36
Advertisement
Table of Contents
