Table of Contents
Advertisement
5
Preparing the water tank (for Humidifying
Operation)
Attention
• Do not pour any of the following into the water tank.
• Warm water (40ºC or above), unclean water, water
containing aroma oil, chemical agents such as
hypochlorous acid, aromatic substances or detergent,
etc.
(Deformation of the unit or malfunction may result)
• Water from a water purifier, ionised alkaline water,
mineral water, well-water etc.
(Propagation of mould or bacteria may result)
• As leaving any residual water in the humidifying tray
will lead to bad odours and dirt build-up, be sure to
discard any residual water in the humidifying tray once
a day to perform the Humidifying Operation.
Fill the water tank with water and check that there is no
water leaking from the bottom of the tank due to dirt
trapped in or around the valve.
If there is water leakage, bad odours or dirt build-up
►Page 36-39
• Do not pour water directly into the humidifying tray.
• Make sure to close the water tank tightly before operation.
(Dust may get inside the tank and cause water leakage)
When supplying water from above
1.
Open the water tank.
Securely hold the grip on the
water tank and slowly pull the
tank toward you while
pressing the lever.
Open to the position
where it will be locked.
2.
Slowly pour water into the spout of the water
tank with a jug.
• Do not touch the lid of
the water tank when
fitting into the unit.
(Fingers may get
caught)
• Do not touch the side
lock part when
pouring water.
(Water tank may fall)
• When supplying water,
clean the water tank
every day by shaking a
small amount of water
inside to perform the
Humidifying Operation.
►Page 37, 38
3.
Close the water tank
Lever
Grip
Read First
• Do not pour water
other than the spout.
(Malfunction may result)
• Do not pour water
beyond the full line
inside the spout.
(Water leakage may
result)
Full line
Press until a catching
sound is heard
• Do not touch the side lock
part when closing.
(Fingers may get caught)
16
Advertisement
Table of Contents
