Danfoss VLT AutomationDrive FC 360 Design Manual page 13

Design Guide | VLT® AutomationDrive FC 360
Safety
2
Safety Symbols
2.1
The following symbols are used in Danfoss documentation.
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates information considered important, but not hazard-related (for example, messages relating to property damage).
The guide also includes ISO warning symbols related to hot surfaces and burn hazard, high voltage and electrical shock, and referring to
the instructions.
ISO warning symbol for hot surfaces and burn hazard
ISO warning symbol for high voltage and electrical shock
ISO action symbol for referring to the instructions
Qualified Personnel
2.2
Correct and reliable transport, storage, installation, operation, and maintenance are required for the trouble-free and safe operation of
the drive. Only qualified personnel are allowed to install and operate this equipment.
Qualified personnel are defined as trained staff, who are authorized to install, commission, and maintain equipment, systems, and
circuits in accordance with pertinent laws and regulations. Also, the qualified personnel must be familiar with the instructions and safety
measures described in this manual.
Danfoss A/S © 2024.01
DANGER
WARNING
CAUTION
NOTICE
AJ435824192086en-000101 / 130R1295 |
11