Setting Configurations; Master Configuration; Slave Configuration - Accusys ACS-76500 Owner's Manual

Setting configurations

The master / slave configurations are set manually by placing jumper heads on the nine
jumper pins on the rear of the RAID box (Only for ACS-76500).

Master configuration

1. Make sure the power is turned off.
2. Place one jumper cap over the central
and right master/slave configuration
jumper pins.

Slave configuration

1. Make sure the power is turned off.
2. Place one jumper cap over the central
and left master/slave configuration
jumper pins.
18
Master and slave settings enable your computer to distinguish two IDE/ATA
devices operating on the same channel. In this case, the settings distinguish
ACS-76500 from your computer's hard disk drive.
It makes little difference which setting you use, but if using master or slave,
you must make sure that the two devices' settings are different. So, if the HDD
is configured as the master drive, ACS-76500 should be configured as slave,
and vice versa.
Accusys 76500/76510