Link Aggregation Setup; Figure 53 Link Aggregation: Configuration; Table 32 Link Aggregation Control Protocol: Configuration - ZyXEL Communications Dimension ES-2108 User Manual

15.4 Link Aggregation Setup

Click Configuration in the Link Aggregation Control Protocol Status screen to display the
screen shown next. See

Figure 53 Link Aggregation: Configuration

The following table describes the labels in this screen.

Table 32 Link Aggregation Control Protocol: Configuration

LABEL
Link Aggregation Control Protocol
Active
System
Priority
Group ID
Active
Dynamic
(LACP)
Port
Chapter 15 Link Aggregation
Section 15.1 on page 113
DESCRIPTION
Select this checkbox to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65,535. The switch with the lowest
system priority (and lowest port number if system priority is the same) becomes the
LACP "server". The LACP "server" controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link Aggregate Control Protocol
(LACP). The smaller the number, the higher the priority level.
The field identifies the link aggregation group, that is, one logical link containing
multiple ports
Select this option to activate a trunk group.
Select this check box to enable LACP for a trunk.
This field displays the port number.
ES-2108 Series User's Guide
for more information on link aggregation.
115