Figure 95 Access Control: Remote Management; Table 59 Access Control: Remote Management - ZyXEL Communications Dimension ES-2108 User Manual

Figure 95 Access Control: Remote Management

The following table describes the labels in this screen.

Table 59 Access Control: Remote Management

LABEL
Entry
Active
Start Address
End Address
Telnet/FTP/
HTTP/ICMP/
SNMP/SSH/
HTTPS
Apply
Cancel
Chapter 23 Access Control
DESCRIPTION
This is the client set index number. A "client set" is a group of one or more "trusted
computers" from which an administrator may use a service to manage the switch.
Select this check box to activate this secured client set. Clear the check box if you
wish to temporarily disable the set without deleting it.
Configure the IP address range of trusted computers from which you can manage this
switch.
The switch checks if the client IP address of a computer requesting a service or
protocol matches the range set here. The switch immediately disconnects the session
if it does not match.
Select services that may be used for managing the switch from the specified trusted
computers.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
ES-2108 Series User's Guide
163