Interface Port-Channel Commands; Table 75 Interface Port-Channel Commands - ZyXEL Communications Dimension ES-2108 User Manual

ES-2108 Series User's Guide
Table 74 Command Summary: Configuration Mode (continued)
COMMAND
dscp <0-63>
pwr interface <port-
list>
usagethreshold
<1-99>
mibtrap

30.11.4 interface port-channel Commands

The following table lists the
Use these commands to configure the ports.

Table 75 interface port-channel Commands

COMMAND
interface
port-
channel
<port-
list>
egress set
<port-list>
igmp-
immediate-
leave
igmp-filtering
profile <name>
igmp-group-
limited
igmp-group-
limited number
<number>
igmp-querier-
mode
<auto|fixed|ed
ge>
206
priority <0-7>
interface port-channel
DESCRIPTION
Enables a port or a list of ports for
configuration.
Sets the outgoing traffic port list for a port-
based VLAN.
Enables IGMP immediate leave on the
port.
Sets the IGMP filtering profile for this port. 13
Limits the number of multicast groups.
Sets the number of multicast groups this
port is allowed to join.
Sets the IGMP querier mode of a port.
Selects auto
normally, fixed
as a querier port no matter there is a
query or edge
querier port which drops any IGMP
queries received.
DESCRIPTION
Maps DSCP value with an
802.1p value.
Enables PoE (Power over
Ethernet) on the specified
ports.
Sets the percentage of power
usage which initiates mib
traps.
Enables mib traps on the
switch. Traps are initiated
when the usage reaches the
limit set up by the
usagethreshold
command.
commands in configuration mode.
to treat the IGMP queries
to always treat the port
to treat the port as a non-
Chapter 30 Introducing Commands
PRIVILEG
E
13
13
13
13
PRIVILEGE
13
13
13
13
13
13