ES-2108 Series User's Guide
3.2 Rear Panel
The following figure shows the rear panel of the switch. The power receptacle is on the rear
panel.
Figure 17 Rear Panel
3.2.1 Power Connector
Make sure you are using the correct power source as shown on the panel.
To connect the power to the switch, insert the female end of power cord to the power
receptacle on the rear panel. Connect the other end of the supplied power cord to the power
source. Make sure that no objects obstruct the airflow of the fans.
3.3 LEDs
The following table describes the LEDs.
Table 3 LEDs
LED
PWR
SYS
ALM
1 - 8 (Ethernet
ports) (ES-
2108, ES-
2108-F, ES-
2108-G and
ES-2108-LC)
48
COLOR
STATUS
DESCRIPTION
Green
On
The system is turned on.
Off
The system is off.
Green
Blinking
The system is rebooting and performing self-diagnostic tests.
On
The system is on and functioning properly.
Off
The power is off or the system is not ready/malfunctioning.
Red
On
There is a hardware failure.
Off
The system is functioning normally.
Green
Blinking
The system is transmitting/receiving to/from a 10 Mbps
Ethernet network.
On
The link to a 10 Mbps Ethernet network is up.
Amber
Blinking
The system is transmitting/receiving to/from a 100 Mbps
Ethernet network.
On
The link to a 100 Mbps Ethernet network is up.
Off
The link to an Ethernet network is down.
Chapter 3 Hardware Overview