Device Messages - Paradyne Hotwire 8775 User Manual

Device Messages

The Device Messages in
may appear in the messages area at the bottom of the ATI screens.
Table 6-1.
8700-A2-GB25-10
Table 6-1, Device
Device Messages (1 of 2)
Device Message What Message Indicates
Access level is The operator requested that
Operator. configuration options be
Configuration is loaded, but does not have
read-only. authority to edit them.
Cannot Save – no All of the login IDs being
Login IDs with Access saved have an access level
Administrator below Administrator.
Command Complete Action requested has
successfully completed.
Invalid Character ( x ) A nonprintable ASCII
character ( x ) has been
entered.
Invalid – Data Terminal Network-initiated loopback
Initiated Loopback was in progress when
Active another selection was made.
Invalid Password Login is required and an
incorrect password was
entered; access is denied.
Invalid – Send Pattern A pattern test was already in
Already Active progress when the Start field
was selected.
Invalid – [ Test ]
The described test was
Already Active already in progress when
another selection was made.
Invalid Test A loopback or pattern test
Combination was in progress when Start
was selected to start another
test, or was active on the
same or another interface
when Start was selected.
February 2001
6. Messages and Troubleshooting
Messages, listed in alphabetical order,
What To Do
If configuration options are to be
edited, use a Login ID that has
Administrator authority.
Change the access level of at
least one Login ID to
Administrator so that
configuration changes can be
made. (Operator-level users
cannot make configuration
changes.) Save the Login IDs.
No action is needed.
Reenter information using valid
characters.
No action is needed.
T
Try again.
T
Contact your system
administrator to verify your
password.
T
Allow test to continue.
T
Select another test.
T
Stop the test.
T
Allow test to continue.
T
Select another test.
T
Stop the test.
T
Wait until other test ends and
message clears.
T
Abort all tests from the Test
menu screen.
T
Stop the test from the same
screen the test was started
from.
6-3