Paradyne Hotwire 8775 User Manual page 88

B. Standards Compliance for SNMP Traps
The tests that affect the enterpriseTestStart, enterpriseTestStop, and the
variable-bindings are different for each particular interface. Diagnostic tests are
only supported on the physical network and user data port interfaces. The specific
tests and variable-bindings are described in the following table:
B-4
enterpriseTestStart/Stop
Interface Variable-Bindings
T
DSL Network ifIndex (RFC 1573)
T
ifAdminStatus (RFC 1573)
T
ifOperStatus (RFC 1573)
T
ifType (RFC 1573)
T
ifTestType (RFC 1573)
The following objects control tests
in SNMP-managed devices:
– noTest – Stops the test in
progress.
– testLoopLLB – Initiates a Local
Loopback.
– testLoopRLB – Initiates a
Remote Loopback.
– testSendMon511 – Initiates a
Send and Monitor 511 test.
– testSendLLBUp – Initiates an
LLB Up message to the
remote unit.
– testSendLLBDown – Initiates
an LLB Down message to the
remote unit.
T
Synchronous ifIndex (RFC 1573)
Data Ports
T
ifAdminStatus (RFC 1573)
T
ifOperStatus (RFC 1573)
T
ifTestType (RFC 1573)
The following objects control tests
in SNMP-managed devices:
– noTest – Stops the test in
progress.
– testLoopDCLB – Initiates a
Data Channel Loopback.
– testLoopDTLB – Initiates a
Data Terminal Loopback.
– testSendDCLBUp – Initiates
an DCLB Up message to the
remote unit.
– testSendDCLBDown –
Initiates an DCLB Down
message to the remote unit.
February 2001
Possible Cause
T
enterpriseTest Start – Any
one of the following tests is
active on the interface:
– Line Loopback
– Repeater Loopback
– Remote Line Loopback
– Send and Monitor 511
T
enterpriseTest Stop – No
tests currently running on
the interface.
T
enterpriseTest Start – Any
one of the following tests is
active on the port:
– Data Terminal
Loopback
– Data Channel Loopback
– Remote Data Channel
Loopback
T
enterpriseTest Stop – No
tests currently running on
the port.
8700-A2-GB25-10