Hotwire 8610 Dslam - Paradyne Hotwire 8775 User Manual

C. Cables and Pin Assignments
50-Pin Telco Connector Pinouts for Model 8785 in a

Hotwire 8610 DSLAM

The three 50-Pin Telco receptacles on the rear of the chassis (labeled 1, 2,
and 3) provide the 2-wire loop interface from each DSL port to the MDF. The
following table lists the pin assignments for each of these interfaces.
Table C-5. 8610 Connector 1–3 Pinouts
C-6
NOTE:
When the 8610 chassis is the base chassis, the Management Control
Processor (MCP) is installed in Slot 1; the Tips and Rings for Slot 1 are
not connected internally and are not active.
Connector 1–3
Port – Direction
Port 1 – RX
Port 1 – TX
Port 2 – RX
Port 2 – TX
Port 3 – RX
Port 3 – TX
Port 4 – RX
Port 4 – TX
February 2001
Connector Pins
(Tip, Ring)
4, 29
5, 30
6, 31
7, 32
8, 33
9, 34
10, 35
11, 36
8700-A2-GB25-10