Repeater Loopback - Paradyne Hotwire 8775 User Manual

5. Testing

Repeater Loopback

A Repeater Loopback (RLB) loops the signal being sent from the data port back to
the data port and to the network interface.
Procedure
To run a Repeater Loopback:
The Repeater Loopback cannot be started when a Line Loopback, DCLB, Remote
DCLB, or Data Terminal Loopback (DTLB) is active.
5-4
NTU/LTU
Network
CAP Framer
Interface
1. Position the cursor at the Start command next to Repeater Loopback on the
Network Tests screen.
2. Press Enter.
The Start command is changed to Stop.
3. To manually stop the test, verify that the cursor is positioned at the Stop
command.
4. Press Enter.
NOTE:
If a disconnected DSL loop is connected while a Repeater Loopback is active,
the connected units will not be able to synchronize.
February 2001
Port
EIA-530
Interface
Port
98-15932
8700-A2-GB25-10