About This Guide
Document Purpose and Intended Audience
This guide contains information needed to set up, configure, and operate 4-port
Hotwire 8775 and 8785 Time Division Multiplexer Symmetric Digital Subscriber
Line (TDM SDSL) Termination Units. It is intended for installers and operators.
Document Summary
8700-A2-GB25-10
Section
Chapter 1, About Hotwire 8775
and 8785 Termination Units
Chapter 2, Using the
Asynchronous Terminal Interface
Chapter 3, Initial Startup and
Configuration
Chapter 4, Monitoring the Unit
Chapter 5, Testing
Chapter 6, Messages and
Troubleshooting
Chapter 7, Security
Chapter 8, IP Addressing
Appendix A, Configuration
Options
Appendix B, Standards
Compliance for SNMP Traps
Appendix C, Cables and Pin
Assignments
February 2001
Description
Describes the features and capabilities of the unit.
Provides instructions for accessing the user interface
and navigating the screens.
Provides procedures for setting up the user interface
and configuring the unit.
Describes using the LEDs, status, and network
statistics to monitor the unit.
Provides information about available tests and test
setup.
Provides information on SNMP traps, device
messages, and troubleshooting.
Presents procedures for creating a login, setting the
effective access levels, and controlling SNMP
access.
Provides information and examples regarding IP
addresses.
Contains all configuration options, default settings,
and possible settings.
Contains SNMP trap compliance information.
Contains connector and interface information.
v