Copy Ports Options - Paradyne Hotwire 8774 User Manual

Copy Ports Options

You can copy the configuration options of DSX-1 interface and DSL loop to
another using the Copy Ports screen. For Copy Ports options, refer to
Copy Ports
sequence:
Table A-3. Copy Ports Options
8774-A2-GB20-40
Options. To access the Copy Ports screen, follow this menu selection
Main Menu Configuration
main/config/copy
Slot 4
Perform Copy
Perform Copy Then Increment
--------------------------------------------------------------------------------
ESC for previous menu
Save
From: Port n
Possible Settings: 1, 2, 3, 4
Default Setting: 1
Controls the source of the configuration options.
1– 4 – The configuration of the selected port is copied.
To: Port y
Possible Settings: 1, 2, 3, 4, All
Default Setting: 2
Controls the target of the configuration options.
1– 4 – The configuration of the selected port is replaced. If Perform Copy Then Increment
is selected, the port number is incremented by 1 after the copy.
All – The configurations of all ports are replaced by the configuration of the selected
From: Port.
NOTE: Peer IP Address and Circuit Identifier are not copied.
February 2001
Current Configuration
COPY PORTS
From: Port 1:
To: Port 2:
MainMenu
A. Configuration Options
Table A-3,
Copy Ports
Hotwire
Model: 8774
Exit
A-7