Resetting AutoRate
The Reset AutoRate function on the Control menu causes the unit to repeat the
AutoRate sequence. The unit attempts to establish the DSL link at the highest rate
(or the value of DSL Line Rate, which represents the AutoRate ceiling when
AutoRate is enabled). If the link fails, the next lower rate is tried until the link is
established.
To access the Reset AutoRate screen, follow this menu selection sequence:
Restoring Access to the User Interface
Improper configuration of the unit could render the user interface inaccessible. If
this occurs, access can be restored using the MCC.
Procedure
To reset the DSL Card using the DSLAM's management card:
You can also restore access to the user interface by reloading the Default Factory
Configuration options using the unit's menus.
Procedure
To restore access to the ATI using the unit's menus:
8774-A2-GB20-40
Main Menu
Control
1. Follow this menu selection sequence:
Configuration
DSL Cards
2. Enter DSL nn , where nn is the slot number for the DSL card you wish to reset.
3. Enter Reset.
4. Enter Y if you want to clear NVRAM also, otherwise enter N.
Entering Y restores the Default Factory Configuration.
5. Enter Y at the prompt to confirm.
NOTE:
When you enter Y, all data connectivity is interrupted.
Main Menu Configuration
February 2001
3. Initial Startup and Configuration
Reset AutoRate
Reset Slot
Default Factory Configuration
3-11