Using The Asynchronous Terminal Interface; User Interface Access; Management Serial Port Settings; Telnet Session Options - Paradyne Hotwire 8774 User Manual

Using the Asynchronous
Terminal Interface

User Interface Access

You can communicate with the asynchronous terminal interface (ATI) using one of
the following methods:
T
T
T
Security can limit ATI access several ways. To set up security or a login ID, refer to
Chapter 7, Security

Management Serial Port Settings

Ensure that the device you connect communicates using these settings:
T
T
T
T
Refer to the installation document for your DSLAM.
8774-A2-GB20-40
Direct connection through the Management Serial port of the DSLAM (locally
or via an external modem).
Telnet session using a Network Management System (NMS) connected to a
LAN/WAN port on the DSLAM.
Telnet session through the Embedded Operations Channel (EOC).
NOTE:
Only one ATI session can be active at a time, and another user's session
cannot be forced to end. To automatically log out a user due to inactivity,
enable the Inactivity Timeout option. To enable the Inactivity Timeout option
(refer to Table A-5, Telnet Session Options,
Options ).
.
Data rate set to 9.6 kbps.
Character length set to 8.
Parity set to None.
Stop Bits set to 1.
February 2001
2
in Appendix A, Configuration
2-1