Logging In To The Hotwire Dslam; Initiating An Ati Session - Paradyne Hotwire 8774 User Manual

2. Using the Asynchronous Terminal Interface

Logging In to the Hotwire DSLAM

You can log in to the Hotwire DSLAM system using either a local
VT100-compatible terminal or a remote Telnet connection.
After you enter your user ID and password, the system displays the Hotwire
Chassis Main Menu. See your Management Communications Controller (MCC)
documentation for information about selecting the unit from the MCC card
selection screen.

Initiating an ATI Session

The Main Menu screen is displayed unless a login ID and password is required or
the ATI is already in use.
If the ATI is already in use, the message connection refused is sent to the
terminal attempting Telnet access.
If security is enabled and Telnet is used to access the terminal unit directly (you did
not log in through the MCC), the system prompts you for a login ID and password.
If you enter an invalid login ID and password three times, the Telnet session closes
or the terminal connection returns to an idle state. Refer to
2-2
Login
Slot: 4
Login ID:
Enter Password:
--------------------------------------------------------------------------------
Ctrl-a to access these functions
February 2001
LOGIN
Chapter 7, Security
Hotwire
Model: 8774
Exit
.
8774-A2-GB20-40