Get Channel Input State Value Of Ad Module - Zmotion ZMIO310 Manual

5
6
7
9
10
11
12
13
14
15
This function is valid for current AD module (or DA module).
⚫
One AD module (or DA module) cannot use multiple ranges, and all channels use the
⚫
same one range, different modules can match with multi-range.
⚫ Type No.1 and No.9 are fixedly used by input module and output module. Type
No.2~No.7 are used only by AD module, Type No.10~No.15 are used only by DA
module.
When using AD module, if input voltage (or current) exceeds the range, then it will
⚫
keep with the maximum value.

6.4.5. Get Channel Input State Value of AD Module

Function description
Object to use
Data dictionary
Examples
ZMIO310 Vertical Bus Expansion Module User Manual V1.0
ZM1115 AD module
ZM1116 AD module
ZM1117 AD module
ZM2111 Output module
ZM2112 DA module
ZM2113 DA module
ZM2114 DA module
ZM2115 DA module
ZM2116 DA module
ZM2117 DA module
This function is only used to read channel input state value of
AD module, and one of AD module has 4 channels, they are
channel 0, channel 1, channel 2 and channel 3.
Analog input module: ZMIO310-4AD.
6051h: 6001h + extension No. of corresponding AD module *
10, please refer to Chapter 6.4.1 for sub-module address
assignment.
'6051h is AD module state dictionary
'read data are saved into TABLE, then get the data through
TABLE command
SDO_READ (0,0,$6051,1,6,100) 'get input state of channel 0
0~20mA
0~5V
-5~5V
--
0~10V
-10~10V
4~20mA
0~20mA
0~5V
-5~5V