Zmotion ZMIO310 Manual page 31

10
11
12
13
14
15
16
17
18
19
20
→ Terminal Wiring
➢ Please use tubular pre-insulated terminals and wire cable that is suitable to wire path
to do user terminal wiring
→Cable production steps:
➢ Strip the cable insulation, the exposed copper part depends on the size of the tube-
type pre-insulated terminal.
➢ Pass the conductor part of the cable into the tubular pre-insulated terminal and crimp
it with a crimping pliers.
→Wire cable connection steps:
➢ Press the spring of the terminal to insert the cable with the tubular pre-insulated
terminal into the port.
➢ Loosen the spring of the terminal, pull the cable lightly to check whether the cable is
firmly connected.
→Note:
When routing terminal cables, avoid bundling them with cables with strong
➢
interference signals such as power cables, and route them separately.
In the case of serious electromagnetic interference on site, shielded cables should
➢
be selected to improve the anti-interference ability.
It is not recommended to use the same power supply for the coupler module and the
➢
ZMIO310 Vertical Bus Expansion Module User Manual V1.0
EARTH Output
OUT8
OUT9
OUT10 Output
OUT11 Output
OUT12 Output
OUT13 Output
OUT14 Output
OUT15 Output
E+24V Power supply (+)
EGND Power supply (-)
Output 9
- Reserved
-
Output 10
Output 11
Output 12
Output 13
Output 14
Output 15
24V power input (+)
24V power input (-)
Shield