H3C SR6616 Manual page 66

LED
(red)
Figure3-6 MCP-X1 LEDs
1
Table3-7 MCP-X1 LED description
LED
GE0 through
1
GE3
(yellow/green)
CF
2
(yellow/green)
3
RUN
(green)
4
ACT
(green)
PALM
5
Status
Steady on
Fast flashing
(8 Hz)
8
Status
Off
Steady green
Flashing green
Steady yellow
Flashing yellow
Off
Steady green
Flashing green
Steady yellow
Off
Slow flashing (1
Hz)
Fast flashing (8
Hz)
Off
Steady on
Off
3-9
Description
occurred.
A fault has occurred on the system or the available power
is insufficient. In this state, identify the system log
immediately.
A critical fault has occurred to the system. In this state,
handle the fault immediately.
2
7 7
Description
The corresponding interface is not connected.
A 1000 Mbps link is present.
Data is being received or transmitted at 1000
Mbps.
A 10/100 Mbps link is present.
Data is being received or transmitted at 10/100
Mbps.
No CF card is present or the CF card is not
recognizable.
A CF card is in position and has been detected.
The system is accessing the CF card. In this
state, do not remove the CF card.
A CF card not provided by H3C.
No power input is available, or the MCP-X1 has
failed.
The MCP-X1 is operating correctly.
The application software is being loaded (in this
case, never power off the device or hot-swap the
MCP-X1; otherwise the MCP-X1 might be
damaged).
The MCP-X1 is in standby state.
The MCP-X1 is in active state.
The system power supply is normal.
3
4
5
５
6