H3C SR6616 Manual page 29

NOTE:
The router does not support the FIP-600 in ESS 7821P09 or later.
Each combo interface on the FIPs has a fiber port and a copper port. Only one port is activated at a
time. By default, the fiber port is activated. To activate a port, use the
command in interface view. For more information about the
fiber }
command, see H3C SR6600/SR6600-X Routers Interface Command Reference(V7).
fiber }
A FIP module is a processing engine and you can install different interface modules on a FIP to
support different network services as needed. This section describes the FIP modules available for
the H3C SR6616 router.
FIP-10
The FIP-10 supports only MIMs, and you can plug at most four MIMs into a FIP.
Front panel
Figure2-10 FIP-10 front panel
(1) Slot 4
(4) Status LED (RUN)
The OPEN BOOK mark indicates that the operator must read the following document before working
with the FIP:
Table2-16 References for FIP operations
Operation
Install and remove the FIP
Install and remove MIMs
Connect network cables
Connect optical fibers
Technical specifications
Item
HIM
MIM
MIC
Hot-swapping
Slot
1
6
(2) Slot 3
(5) Slot 1
Reference
H3C SR6616 Router Installation Guide
Specification
Not supported
4 MIMs supported at the same time
Not supported
Supported
Four
2-13
combo enable { copper |
combo enable { copper |
2
5 4
(3) OPEN BOOK mark
(6) Slot 2
3