Rpe-X5E - H3C SR6616 Manual

NOTE:
SDRAM stores running configuration and buffers data during data forwarding.

RPE-X5E

CAUTION:
If you connect a large-sized USB drive directly to the RPE-X5E MPU, the right ejector lever of the
MPU might be damaged. You must use a USB extension cable to connect a large-sized USB drive
to the USB port on the MPU.
NOTE:
The Ethernet fiber ports SFP+0 and SFP+1 on the RPE-X5E MPU are only used for virtual machine
services and do not support Layer 2 or Layer 3 forwarding. For information about how to use these
two fiber ports, see H3C SR6600 Router Series VM Deployment Guide.
Figure2-4 RPE-X5E MPU
8
(1) 10GBASE-R-SFP+ port (SFP+1)
(3) Management Ethernet port (MANAGEMENT)
(5) 10GBASE-R-SFP+ port (SFP+0)
(7) MPU status LEDs
Table2-4 RPE-X5E specifications
Item
Flash
Memory type and size
Built-in drive
Console/AUX port
Management Ethernet port
10GBASE-R-SFP+ port
USB port
Power button
Hot swapping
1
7 6
5
2
4 3
(2) Console/AUX port
(4) Management Ethernet port LED
(6) USB port
(8) Power button
Specification
64 GB
DDR4 SDRAM
Default: 32 GB
512 GB mSATA SSD (optional)
NOTE:
The RPE-X5E does not support SSC-enabled mSATA drives.
1, 9600 bps (default) to 115200 bps
1 (10Base-T/100Base-TX/1000Base-T)
2
1 USB 3.0 port (Host mode, Type A connector)
1
Supported
2-4