H3C SR6616 Manual page 26

Table2-12 Fiber Ethernet port specifications
Item
Connector type
Transceiver module type
Interface standards
Operating mode
10 Gbps Ethernet port
The MCP-X2 provides two 10 Gbps Ethernet ports. 10 Gbps SFP+ ports do not support 1000 Mbps
transceiver modules.
Table2-13 10 Gbps Ethernet port specifications
Item
Protocol
Connector type
Transceiver module type
Physical layer
Transmission rate
10GBASE-R-SFP+ port
Item
Connector type
Transceiver module type
Interface standards
Operating mode
Reset button
CAUTION:
• If you perform no save operation before resetting the router, the current system configuration will
be lost.
• Never press the reset (RESET) button when the RUN LED is flashing fast or when the router is
accessing the CF card or a USB storage device. Otherwise, the file system of the router might be
damaged.
To reset the current MPU, press the reset button.
•
If you press the reset button when only one MPU is equipped, the whole system will be reset.
•
To perform an active/standby switchover when two MPUs are equipped, press the reset button
on the active MPU. The system automatically switches the services to the standby MPU,
without interrupting the ongoing services.
•
If you press the reset button on the standby MPU when two MPUs are equipped, the standby
MPU will be reset but the system operation will not be affected.
Specification
LC
SFP
802.3, 802.3u, and 802.3ab
1000 Mbps, full duplex
Specification
802.3ae
LC
SFP+
10GBASE-R/W
•
LAN PHY—10.3125 Gbps
•
WAN PHY—9.95328 Gbps
Specification
LC
SFP+
802.3ae
10 Gbps, full duplex
2-10