Service Aggregation Platform Modules; Sap-48Gbe - H3C SR6616 Installation Manual

GE SFP port specifications
Table 58 FIP-680 GE SFP port specifications
Item
Connector
Transceiver module type
Synchronous Ethernet
1588v2.2
Interface standards
Duplex mode
Copper Ethernet port specifications
Table 59 FIP-680 copper Ethernet port specifications
Item
Connector
Interface type
Supported frame format
Interface speed and
duplex mode

Service aggregation platform modules

IMPORTANT:
Use transceiver modules for the service modules provided by H3C only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when a
transceiver module from another vendor is installed.
Each combo interface on the service modules has a fiber port and a copper port. Only one port is
activated at a time. By default, the fiber port is activated. To activate a port, use the combo enable
{ copper | fiber } command in interface view. For more information about the combo enable
{ copper | fiber } command, see H3C SR6600/SR6600-X Routers Interface Command
Reference(V7).
A service aggregation platform (SAP) module provides network ports for receiving packets from the
network and sending packets to the network. This section describes the SAPs available for the H3C
SR6616 router.

SAP-48GBE

The SAP-48GBE has 48 high-performance RJ-45 ports that can be both routed and switched. One
two-color LED is available for each port to indicate their activity and link status. The module also has
a RUN LED to indicate the module operating status.
Specification
LC
SFP
Not supported
Not supported
802.3, 802.3u, and 802.3ab
1000 Mbps, full duplex
Specification
RJ-45
Autosensing
Ethernet_II
Ethernet_SNAP
10 Mbps
100 Mbps
1000 Mbps
134
Half/full duplex, auto-negotiation
Half/full duplex, auto-negotiation
Full duplex, auto-negotiation