H3C SR6616 Manual page 64

LED
2
PALM
(red)
3
IRF
(yellow/green)
SFP+0 and
4
SFP+1
(green)
5
MANAGEM
ENT
(yellow/green)
6
ALM
(red)
7
ACT
(green)
8
Power
button
(red/green)
Status Description
yellow
Off
Slow flashing
green
Comware
Fast flashing
stage
green (5
seconds)
Steady on The system power is insufficient.
Off The power system is operating correctly.
Slow flashing The device is in IRF mode and the MPU is the global
green active MPU.
The device is in IRF mode and the MPU is a standby
Steady green
MPU.
The device is in IRF mode but the IRF configuration
Steady yellow
has failed.
Off The device is in standalone mode.
Steady green NOTE:
After a link is set up,
using the command to
bring up or shut down
Flashing green
the port does not
change the LED status.
Off No link is present.
Steady green A 1000 Mbps link is present.
Flashing green Data is being received or transmitted at 1000 Mbps.
Steady yellow A 100 Mbps link is present.
Flashing yellow Data is being received or transmitted at 100 Mbps.
Off No link is present or the port is faulty.
Fast flashing
USB-based automatic configuration has failed.
(10 seconds)
Steady on A fault has occurred on the system.
The system is operating correctly and no alarm has
Off
occurred.
Steady on The MPU is in active state.
Off The MPU is in standby state.
Fast flashing The MPU has been powered up to start up the
red Comware system.
Slow flashing
The BIOS is starting up.
red
Slow flashing
The BootWare is starting up.
green
The Comware system starts up and is operating
Steady green
correctly.
3-7
Hardware failure or no power input.
The system is operating correctly.
USB-based automatic configuration has
succeeded.
A 10 Gbps link is present.
Data is being received or
transmitted at 10000 Mbps.