Indicator Lamps; Changing The Locking Status Display - Assa Abloy effeff 842-SA1 Installation And Mounting Instructions

Functions and operation

Indicator lamps

The signal indicator LED ( 1
locking status as well as the cause of errors ("Signalling",
page 28).
The locking status display can be changed or switched off.
This setting has no effect on the signalling of fault causes.
The operational status display LED (
flashes blue as long as the swing bolt is working correctly.
By default, the operational status display LED is covered by
a screw, which can be removed if necessary.

Changing the locking status display

Prerequisite: the motorized swing bolt 842-SA1 is con-
nected to the power supply.
1 Gently press and hold the pressure switch for approx.
3 seconds to activate the setting mode.
 The indicator LED lights up white.
2 Toggle between display modes by repeatedly pressing
the pressure switch until the desired mode is selected:
Display mode
Mode 1 (red)
Mode 2 (green)
Mode 3 (purple)
3 Press and hold the pressure switch for approx. 3 seconds until the indicator LED goes out.
 The display mode has been changed.
) of the swing bolt signals the
2 ) of the swing bolt
Door locked
Red
Green
—
1
2
Door unlocked
Green
Red
—
EN
27