Tesla CYBERTRUCK Owner's Manual page 205

4. Remove the two bump stops (one on each side
above the headlights) by turning them
counterclockwise.
5. Remove the windshield washer fluid cap.
6. Using a trim tool or flat, plastic tool, remove the two
pieces of trim on the bottom of the frunk lining to
expose the four bolts that hold the lining in place.
7. Using a 10 mm socket, remove the four bolts on the
bottom of the frunk and the two bolts beneath the
maintenance panel.
Maintenance
Parts and Accessories
8. Carefully lift the frunk lining partially upward and
unplug the emergency interior release connector.
Once the connector is unplugged, the frunk lining can
be removed.
CAUTION: As you remove the frunk lining, be
careful not to damage or jostle the connector
for the powered frunk emergency interior
release.
9. Locate the shrink-wrapped wires. This is the power
feed.
203