Tesla CYBERTRUCK Owner's Manual page 200

Windshield Wiper Blade, Jets and Fluid
2. Place a towel between the wiper arm and windshield
to avoid scratching or cracking the windshield.
3. Lift the wiper arm a short distance away from the
windshield, just far enough to access the wiper blade.
CAUTION: Wiper blade does not lock into a
lifted position. Do not lift the wiper arm beyond
its intended position or drop it onto the
windshield.
4. While holding the wiper arm, press the locking tab,
then slide the blade away from the arm. Set the wiper
blade next to the wiper arm.
5. Disconnect the washer hose from the wiper blade by
pulling the hose from the barb fitting.
198
6. Connect the new washer hose to the barb fitting on
the new wiper blade.
7. Align the new wiper blade on the wiper arm and slide
it toward the base of the wiper arm until it locks into
place.
8. Ensure the wiper blade is fully secured by lightly
pushing and pulling on the blade. The blade should
not jostle or move around.
9. Remove the towel and gently place the wiper blade
against the windshield.
Washer Jets
The windshield washer fluid sprays from nozzles along
the length of the wiper blade. You cannot adjust them. If
a windshield washer nozzle becomes blocked, use a thin
strand of wire to clear any blockages.
If the blade is not dispensing washer fluid, make sure
there is enough wiper fluid in the reservoir and refill if
needed. If this issue still persists, check the hose
connection between the arm and blade for any leaks,
kinks, or disconnections.
WARNING: Do not operate the washers while
cleaning Cybertruck. Windshield washer fluid can
irritate eyes and skin. Read and observe the
washer fluid manufacturer's instructions for safe
handling.
Owner's Manual