Opening The Powered Frunk With No Power - Tesla CYBERTRUCK Owner's Manual

Opening the Powered Frunk with No Power

In the unlikely event that Cybertruck has no low voltage
power, you will be unable to open the powered frunk
using the touchscreen, mobile app, or powered frunk
button.
It is necessary to open the powered frunk before
attempting to jump start Cybertruck. For more
information, see Jump Starting on page
To open the powered frunk when Cybertruck has no
power, you need a power source that provides between
9V and 16.5V (such as a 12V portable jump starter or
another vehicle), or a power source that provides
between 30V and 50V. A standard 9V battery may not
have enough power to open the powered frunk if
Cybertruck has no power. Instead, use a portable jump
starter or another vehicle.
The steps below assume you are using an external low
voltage power supply (such as a portable jump starter).
NOTE: The following steps do not open the powered
frunk if Cybertruck is locked and has low voltage power.
1. Locate the front trunk access terminal beneath the
front-left wheel well, behind the headlights.
2. Use your finger to loosen the cover, then pull it down
and toward you to remove it and expose the
terminals. The cover is attached to a loop of cable
containing both the red positive (+) and the black
negative (-) terminals.
In Case of Emergency
225.
3. Carefully pull the terminals out from the cavity.
4. Connect the low voltage power supply's red positive
(+) cable to the red positive (+) terminal.
5. Connect the low voltage power supply's black
negative (-) cable to the black negative (-) terminal.
NOTE: Applying external low voltage power to these
terminals only releases the front trunk latches. You
cannot power the low voltage system using these
terminals.
223