Carrying Accessories And Crossbars - Tesla CYBERTRUCK Owner's Manual

WARNING: Tesla assumes no responsibility for
damage or injuries resulting from installing and
using a carrier or crossbars, for any omissions in
the instructions accompanying a carrier or
crossbar, or for your failure to follow the
instructions. Damage caused by using a carrier or
crossbars is not covered by the warranty.
Carrying Accessories
CAUTION: The hitch assembly is designed to
support vertical loads up to 160 lb (72 kg).
Exceeding this maximum weight can cause
damage.
The hitch receiver is designed to support vertical loads
up to 160 lb (72 kg). When carrying bicycles, skis, or
other items on the Cybertruck's hitch, always check to
ensure that the maximum weight is not exceeded. When
the carrier weighs 40 lbs (18 kg), the weigh threshold is
sufficient for carrying two bicycles weighing
approximately 60 lb (27 kg) each, or four items
weighing approximately 30 lbs (14 kg) each.
CAUTION: An accessory carrier attached to the
rear of Cybertruck may obscure your view from
the rear view mirror and the rear camera.
Follow the instructions provided with your accessory
carrier to install onto Cybertruck. Observe all regulations
and legal requirements in your state/region that apply to
carrying accessories.
Cybertruck includes the wiring necessary for using an
accessory carrier equipped with lights (see
Connections on page 109). Cybertruck also includes
Trailer Mode software (see
When you connect an accessory carrier's
wiring harness, Cybertruck detects a
connection for trailer lights and displays
this indicator on the touchscreen to
indicate that Trailer Mode is disabled.
When carrying accessories, periodically confirm that the
accessory carrier and its cargo remain secure at all
times, and if applicable, that the lights on the accessory
carrier are working.
Installing Brackets onto the
Appliques
1. Open all 8 applique doors.
Towing

Carrying Accessories and Crossbars

Electrical
Trailer Mode on page 106).
2. Use the provided torque wrench to loosen and
remove the nuts that are fastened to the threaded
studs located within the applique doors.
3. Install a bracket by positioning the bracket so that
the raised arrow on it is directed outward, away from
the vehicle. Align it with the threaded studs and set it
in place.
4. Use the nuts that were removed in step 2 and tighten
them back onto the threaded studs with the provided
torque wrench.
5. Repeat steps 2-4 for the remaining applique doors.
NOTE: After installing the brackets once, you can
leave them installed for future use, unless you want to
move the crossbars to different locations on the
vehicle.
Installing Crossbars
NOTE: Installing the crossbars requires two people.
111