Tesla CYBERTRUCK Owner's Manual page 172

Charging Instructions
Stopping Charging
Stop charging at any time by pressing the button on the
charge cable to disconnect, or touch Stop Charging on
the touchscreen or mobile app. To disconnect the
charge cable:
1. Ensure your vehicle is unlocked. To prevent
unauthorized unplugging of the charge cable, the
charge cable latch remains locked and Cybertruck
must be unlocked before you can disconnect the
charge cable.
2. Press and hold the button on the connector handle to
release the latch.
3. Pull the connector from the charge port. The charge
port door automatically closes.
To disconnect the charge cable when using an adapter
at a public charge station:
1. Unlock Cybertruck.
2. While holding the public charging handle in one hand
and the adapter in the other hand, press and hold the
button on the public charging handle and pull both
outwards, removing the handle and adapter at the
same time.
NOTE: If the charging station handle separates from
the adapter, leaving the adapter in Cybertruck, use
the touchscreen to unlock the charge port.
3. Press and hold the button on the charging handle
again to release the adapter from the public charging
handle.
The charge port door closes automatically shortly after
you remove the charge cable.
Charge Settings
Access charge settings by touching Controls > Charging
when Cybertruck is in Park. You can also touch the
Battery icon on the touchscreen to access charge
settings.
170
RED: A fault is detected and
charging has stopped. Check
the touchscreen for an alert.
In some cases, an alert can be
easily cleared by unplugging
the charge cable, returning it
to the charger, then trying
again. In other cases (such as
a tripped fuse or a faulty
charger), you may need to
check the power source. If
the red light persists, try
using a different charger.
1. Energy available: Displays the remaining energy
available in the high voltage Battery. To show the
remaining energy as estimated driving distance
(miles or kilometers) rather than a percentage, touch
Controls > Display > Energy Display.
2. Set charge limit: Adjust the charge slider to the level
of charging you want. The setting you choose applies
to immediate and scheduled charging sessions.
NOTE: Refer to the information on the touchscreen
(navigate to Controls > Charging) or mobile app
(touch the Charging icon) for recommended daily
and trip charging limits.
NOTE: A portion of the Battery image may appear
blue. This indicates that a small portion of the energy
stored in the Battery is not available because the
Battery is cold. This is normal and no reason for
concern. When the Battery warms up, the blue
portion no longer displays.
Open/Unlock Charge Port
When not charging, touch Open Charge Port or Unlock
Charge Port to open the charge port door or to unlock
the charge cable from the charge port.
Stop Charging
Use Stop Charging when you are finished charging.
Charge Current at this Location
The current automatically sets to the maximum current
available from the attached charge cable, unless it was
previously reduced to a lower level. If needed, touch - or
+ to change the current (for example, you may want to
reduce the current if you are concerned about
overloading a domestic wiring circuit shared by other
equipment). It is not possible to set the charging current
to a level that exceeds the maximum available from the
attached charge cable. When you change the current,
Cybertruck remembers the location.
NOTE: When charging with the Mobile Connector, your
vehicle may automatically select a default charge
current. Override this default current to a higher setting
by customizing Charge Current at this location or
through the mobile app.
Owner's Manual