Selecting The Washing Programme - Smeg GW0160 Series User Manual

4.5

SELECTING THE WASHING PROGRAMME

The device has an interface, with segment display and 7 LED-lit symbols, for user-device communications.
To run a program:
1. Close the door by shutting it against the appliance until the lock clicks shut. The buttons are only enabled
with the door closed.
2. If the appliance is off, switch it on by pressing the On/Off key (hold down for 2 seconds)
3. Use the Selection buttons to select the program.
4. Once the selection has been made, the Functions button can be used to scroll through the program
parameters.
5. Press the Start/Stop button to start the cycle (hold it down for 2 seconds).
6. Two beeps sound to indicate the start of the cycle.
7. Once the selected program has been successfully completed, the display shows End".
8. Interrupting the cycle: A cycle in progress can be interrupted by pressing the Start/Stop button. A
After the cycle has been interrupted, the options available vary depending on conditions in the chamber:
i. If the temperature in the chamber is below 40°C: the door can be opened. If the door is
ii. If the temperature in the chamber is above 40°C: a reset cycle is required since the door
3
fig. 8 – Standard procedure for starting a cycle. 1 Select the program using the Selection buttons. 2 Check the program parameters: Functions
SYMBOL
User manual
closed again within 1 minute, the cycle can be restarted from the phase where it was
interrupted by holding down the Start/Stop button.
cannot be opened.
button. 3 Start the program: hold down the Start/Stop button.
CONTROL PANEL SYMBOLS
MEANING
On/Off
Start / Stop
Selection
SYMBOL
GW0160 Series
1
MEANING
Functions
Door opening
Selection
Page 20 - 70
2