Table of Contents
Advertisement
12.4
ELECTRICAL CONNECTIONS
Warning
Note
The CSS-VC1 or CSS-VC2 is to be supplied in voltages 230 V/50 Hz or 115 V/50-60 Hz (for the circuit diagram see
appendix). Protection is provided as standard with two 6.3 A fuses. These fuses are located in the cold-device socket.
The electrical connection is via the 2 m [≈ 6.56 ft] long power cord with cold-device connector depending on the
mounting of the connection plate either at the back or in the lid of the housing (see chapter 12.2).
12.4.1 GROUP CONNECTION ALARM (PART NO. 01G6170)
The electrical connection of the general alarm (condenser, fluid and flow) is via a 6-pin connector, depending on
the mounting of the connection plate, either at the back or in the lid of the housing.
The corresponding 6-pin socket is included.
The connector is wired as follows:
Internal
Lower channel
Channel 1
Upper Channel
Channel 2
Figure 6
Plug assignment for the version with group alarm (Part No. 01G6170)
20
Incorrect voltage can destroy the device. On connection, ensure the correct
mains voltage in accordance with the rating plate!
For the erection of power installations with nominal voltages up to 1000 V the
requirements of VDE 0100 and relevant standards and regulations must be
complied with!
Status Alarm
Socket/Female X2
External
6
5
4
3
2
1
CSS-VC-1.6 | 1.02.01
Contact load
Contact rating
24 V AC/DC 0.5 A
Plug/male connector type Phoenix MSTB
2,5/6-STF 5,08
www.mc-techgroup.com
Advertisement
Table of Contents
