Table of Contents
Advertisement
19.3.5 CLEANING THE PUMP HEAD
When changing flexible tube or other parts, inspect all parts for dirt before assembling the pump head and clean
them if necessary.
We recommend cleaning the parts with a dry cloth. Solvent should not be used, because it can damage the plastics
and synthetic rubber parts. Use oil-free compressed air to clean the parts if available.
19.3.6
REPAIR INFORMATION FOR INTEGRATED PERISTALTIC PUMP TYPE SR25.2
Note
19.4
CLEANING THE COOLING FINS OF THE COMPRESSOR COOLER
To prevent a decrease of the cooling capacity the cooling fins have to be cleaned from dust periodical. For this
purpose blow compressed air into the ventilation grid at the right side of the housing.
Note
20
PROPER DISPOSAL OF THE DEVICE
At the end of the life cycle of our products, it is important to take care of the appropriate disposal of obsolete
electrical and non-electrical devices. To help protect our environment, please follow the rules and regulations of
your country regarding recycling and waste management.
www.mc-techgroup.com
Aggressive condensate possible!
Media residues in tubing!
Chemical burns caused by aggressive media possible!
Wear protective gloves and protective glasses!
Wear proper protective clothing!
When sending the peristaltic pump to M&C customer service for repair, please indicate
the type of medium pumped. Before shipping the pump, please remove hazardous or
aggressive contaminations from all parts of the pump!
With clean cooling fins a DIN A4 sheet of paper is sucked in and clings to the right
side of the housing.
CSS-VC-1.6 | 1.02.01
45
Advertisement
Table of Contents
